The fairing can now be lifted from the mini moto

The exhaust is fixed to the underside of the engine by two bolts via a gasket.The throttle cable can be removed from its fitting on the top of the carburettor. Remove the two bolts with an alan key making sure that you do not lose the gasket washer. Once the pull start has been removed you will see the wire that comes from the stop switch. Unscrew the screw at the front end of the seat fairing and remove the petrol cap. Undo this bolt with a spanner and an alan key.Remove the pull start from the engine by unscrewing the three holding screws.

The engine is free from its mechanical fittings, the engine then needs to be removed from the mini motos frame. When the chain is loose enough you can remove it from the front sprocket. The exhaust is fixed to the mini motos frame by a bolt located just under the seat fairing toward the back of your mini moto. The engine can now be completely removed from the mini moto. To do this loosen the back wheel nuts and the tensioning bolts. Replace the fuel tank petrol cap and remove the fuel tank by pulling the rubber tube of the nipple on the top of the carburettor. The back wheel can now be manoeuvred toward the front sprocket loosing the chain.Firstly you will need to remove the mini moto's fairing.Many mini moto modifications will require you to remove the engine from the mini moto. For expert advice and Mini Moto information please. parallel Twin Screw Barrels Manufacturers The exhaust can now be slid out past the engine and removed form the mini moto. You may want to double the rubber fuel tube over and secure it in this position with a clothes peg.

The three screws located on the underside of the engine are the last fixings to be undone.Remove the bottom fairing by unscrewing the holding bolts (two on each side), this frees the bottom fairing from the top. This is to stop fuel leaking out.Once you have removed the fairing, you will need to take the chain off the front sprocket.The next step is to Remove the Exhaust. The fairing can now be lifted from the mini moto. This is why I have produced the following guide. Unplug this.Start with the seat fairing, unscrew the four seat screws and remove the seat. The bottom fairing is now free. The bolt at the top of the engine must be undone first using the alan key. Pull the rubber seal up so that the locking nut can be unscrewed, the throttle can now be pulled from the carburettor along with the needle valve and spring. Unscrew the two bolts on the underside of the bottom fairing.Matt Tong has been importing and riding Mini Motos for two years. The top fairing is only now held on by one last bolt located in between the handle bars at the front of the mini moto.